How to Put a Pop Filter on a Mic Stand
Updated Nov 13, 2026 · By 
Jonah Mercer · Editorial policy
As an Amazon Associate I earn from qualifying purchases. Buying through the Amazon links on this page costs you nothing extra. Full disclosure
Clamp the pop filter to the mic stand, bend the gooseneck so the screen sits between your mouth and the mic, and tighten the clamp so the filter stays in place. The Aokeo filter here clamps to a stand with a 360° gooseneck.
Clamp the filter to the mic stand
Open the clamp on the filter arm and fit it around the mic stand, below the mic. Tighten the screw on the clamp until the arm stays put and does not slide down the stand. The Aokeo filter uses a screw clamp with a grip that holds tubular stands and booms.
Bend the gooseneck into place
Bend the gooseneck so the screen faces the mic and sits between your mouth and the mic. Set the screen close to the mic, with a gap between the screen and the mic. Move the screen until it sits square in front of the mic, then leave the arm alone so it holds its angle.
Check the screen sits between mouth and mic
Sit or stand where you record and check that the screen sits between your mouth and the mic. The screen should cover the mic from your mouth, so air blasts hit the screen before they reach the mic. If the screen sits to the side, bend the gooseneck until it lines up.
Fit a foam cover over the mic
For a foam cover, stretch the foam over the mic until it covers the mic body. The YOUSHARES cover fits Fifine K669 mics, and the SUNMON cover fits HyperX QuadCast mics, so match the cover to your mic. A foam cover needs no clamp and no stand of its own.
Test the setup before you record
Say B and P sounds into the mic and listen for air blasts. If you hear a blast, move the screen closer to the mic or bend the gooseneck to change the angle. Leave the filter in place once the blasts stop hitting the mic.
What you need
Aokeo Professional Microphone Pop Filter Mask Shield
A dual layer pop filter with a 360° gooseneck and a screw rotating clamp that holds tubular stands and booms.
- Dual layer screen
- Gooseneck
- 1-year warranty stated
penypeal Microphone Wind Shield Pop Filter Microphone Isolation
A foam isolation ball with a 5-sided seal and a double layered screen, for mics 50 to 75 mm in diameter.
- Dual layer screen
YOUSHARES K669B Pop Filter
A foam windscreen made for Fifine K669 mics that reduces wind, air blasts and plosive noise.
SUNMON Mic Pop Filter for HyperX QuadCast
A foam cover made for HyperX QuadCast mics that is washable and reusable.
These come from our ranked list Best Pop Filter for Mic, which compares them spec by spec.
Frequently asked questions
How far should the pop filter sit from the mic?
Close enough that the screen covers the mic from your mouth, with a gap between the screen and the mic. Bend the gooseneck to move the screen, and leave a gap so the screen does not touch the mic.
Can I use a pop filter with any mic?
The Aokeo filter fits Blue Yeti mics and any other mic on a stand, with a clamp that holds tubular stands and booms. Foam covers fit only the mics they are made for, so match the cover to your mic model.
Does a foam ball fit on a mic stand?
The penypeal foam ball fits mics with a diameter of 50 to 75 mm, and it mounts on desktop stands, tripods, cantilever arms and floor stands. Check your mic diameter against that range before you buy.
Ranked pop filters lists
More how-to guides
Product details come from each Amazon listing and can change. Check the listing before you buy.